10/5/2023 0 Comments Sonoff touch screenTo control the brightness you may use the PWM command instead of GPIO command. If =1 //change this =0 for LED off when relay is closed What you prefer.ĭepending if you want the LED to be on or off when the relay is open/closed you may use this rule: Push button active high will make the relay pull when button is released, push button active low will pull the relay (instantaneously) when button is touched. Soldered board seen from bottom, square via as far left out of the four. Remember to remove GND from GPIO-0 once flashed.Īlready soldered board fitted in the casing. In order to get the ESP8285 in flash mode the GPIO-0 needs to be LOW.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |